Loopback 2.2.12
for exampl...e simply starting up wsjtx configured to access the loopback device for xdax channel causes all audio on the loopback device to just stop...and freezes that loopback device in noop mode..until the wsjtx shuts down...
Loopback 2.2.12
i have also been able to verify this by siimply connecting the macbook air speaker to the loopback device as a monitor.....add it and loopback goes dead, remove speaker and audio comes back thru the loopback device
Thank You. I will be ordering a license for this Loopback software. I am going to experiment with routing audio from a DAW (GarageBand) to DAX TX channel. I will be using DAW plugins to do audio compression, EQ and Limiting. I have a MOTU M2 USB Audio Interface that I plug my XLR mics into. My MacBook is 14 Pro with M1 processor running SmartSDR for MacOS. This is an experiment to improve audio quality for use in AM mode. Anyway, thanks for heads up in 2.2.12 update of Loopback SW. Dan WA1QZX
You can download Loopback 2.2.12 for Mac from our application library for free. This Mac app was originally created by Rogue Amoeba Software, Inc. The most recent installation package that can be downloaded is 23.4 MB in size. The program is categorized as Audio & Video Tools. Our antivirus check shows that this Mac download is malware free.
To have gpg2 read your commands from stdin, use --command-fd=0. To have gpg2 read the passphrase of the master key from where it reads your commands from, use --pinentry-mode=loopback. (gpg2 --help does not list these switches, but they are documented in the man page.) Using these switches, you can communicate with gpg2 non-interactively.
Specifying a source IP address to configure a loopback interface is highly recommended. If you do not configure a loopback interface, the router selects the best available local address, which could be any IP address configured on a core-facing interface. This configuration may prevent establishment of a control channel. The loopback address must be reachable from the core networks.
Hairpin pseudo-wire or Local switching (from one port to another port in the same router). The configuration is done only on R2 and consists of configuring two unidirectional tunnels pointing to two loopbacks, which are both on router R2. 041b061a72